K11 Owners Group Forum Index K11 Owners Group
K11 Owners Group
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Pinging

 
Post new topic   Reply to topic    K11 Owners Group Forum Index -> Tech
View previous topic :: View next topic  
Author Message
molerat
Big Brick Rider


Joined: 14 May 2012
Posts: 69
Location: Phoenix, AZ

PostPosted: Wed Oct 29, 2014 5:22 pm    Post subject: Pinging Reply with quote

Hi all.
I just rode my bike from CO. to SoCal last week about 1300 miles (took some side rodes). The reason for the post is since I arrived I have been hearing pinging from the engine. Hard to tell where from. thought it was from behind the head cover. but then I thought maybe gas. I have always put 91 octane in and usually low octane is cause for pinging so now I am confused.
Question for the CA owners of LT's , is there something in the gas that would cause this, I know there is a lot of additives in your gas for the smog restrictions etc.
I am planning on the return trip on Friday and just wanted to make sure there is nothing more serious involved. It runs great like it always has just concerned about the unusual noise.

Thanks again everyone this site rocks and I hope to get home safe


Brian
_________________
Brian

1995 K1100 LT
1952 HRD Vincent Black Shadow, Series C
Back to top
View user's profile Send private message
Sonu
Flying Brick Rider


Joined: 15 Jan 2004
Posts: 400
Location: San Jose, CA

PostPosted: Wed Oct 29, 2014 6:13 pm    Post subject: Reply with quote

Hi Brian,

I've had my KLT in California since 2000.
I've never had any pinging issues.

Sanjiv
_________________
1997 K1100LT "Ziggy" _GarminGPS_Corbin saddle_K Guards _Hyperlights_Fog lights_Eastern Beaver Relays_Cee Bailey_4"speakers_Michelin PR4's_MoS2_Spiegler lines_TPMS_VDO
Back to top
View user's profile Send private message
John Clauss
Flying Brick Rider


Joined: 04 Apr 2003
Posts: 732
Location: Robesonia, PA

PostPosted: Thu Oct 30, 2014 8:34 am    Post subject: Reply with quote

I have heard of bikes pinging at high altitude when coming from low, but never the other way around. Odd.
_________________
1997 K1100LT
1975 R75/6

It will bring you so close to nausea, it will make you sick! - Big Al
Back to top
View user's profile Send private message Visit poster's website
molerat
Big Brick Rider


Joined: 14 May 2012
Posts: 69
Location: Phoenix, AZ

PostPosted: Thu Oct 30, 2014 12:46 pm    Post subject: Reply with quote

thanks, I guess I will just keep fingers crossed I don't get stuck in desert. Smile Sometimes it sounds like it may be loose valves and seems to only do it when at high rpm's and I let off the throttle quickly.
_________________
Brian

1995 K1100 LT
1952 HRD Vincent Black Shadow, Series C
Back to top
View user's profile Send private message
old guy old bike
Flying Brick Rider


Joined: 18 Jul 2007
Posts: 373
Location: Lisbon, OH

PostPosted: Fri Oct 31, 2014 12:12 pm    Post subject: Reply with quote

Wonder if it might be something silly like the heat shield under your left foot. You would not have pinging when you let off the throttle. It only happens under load, mostly when you are lugging it.
_________________
1993 K1100LT
2003 K1200GT Gone but not forgotten
2014 Victory Crossraods
Back to top
View user's profile Send private message Send e-mail Visit poster's website
atlantaboblutz@live.com
Big Brick Rider


Joined: 10 Nov 2011
Posts: 60
Location: Atlanta, Georgia

PostPosted: Fri Oct 31, 2014 5:49 pm    Post subject: Reply with quote

I'd agree ... I'd check for loose bits first (the rear section my fender came off on a recent trip when the top bolt came out). In combo - to eliminate gas... you could always buy a high quality octane booster to add to a full tank.

You didn't say if you tested by revving while on the center stand. You can hear quite a bit with a long screw driver against various locations on the engine and your ear against the other side.
_________________
Thanks,
Bob
Atlanta GA

'94 K1100 LT
'76 R75/6
Back to top
View user's profile Send private message
molerat
Big Brick Rider


Joined: 14 May 2012
Posts: 69
Location: Phoenix, AZ

PostPosted: Sun Nov 02, 2014 4:45 pm    Post subject: Reply with quote

I made it back to COS, with no problem, in fact it ran superbly as usual. Still have the gremlin noise though when letting off the throttle from a high RPM. I will try those item you guys mentioned when I get some time. I also forgot to mention my ABS lights came on(alternating, tried the reset but came back on after 1-2 hours of riding) and had to ride over 1000 miles with them on will search the forum for solutions.
_________________
Brian

1995 K1100 LT
1952 HRD Vincent Black Shadow, Series C
Back to top
View user's profile Send private message
Jim
Site Admin


Joined: 17 May 2003
Posts: 3841
Location: WHERETHEFUNNEVERENDS

PostPosted: Sun Nov 02, 2014 7:23 pm    Post subject: Reply with quote

Don't know about the pinging...

Check the clearance on the ABS sensors first.


molerat wrote:
I made it back to COS, with no problem, in fact it ran superbly as usual. Still have the gremlin noise though when letting off the throttle from a high RPM. I will try those item you guys mentioned when I get some time. I also forgot to mention my ABS lights came on(alternating, tried the reset but came back on after 1-2 hours of riding) and had to ride over 1000 miles with them on will search the forum for solutions.

_________________
Jim
1997 K1100LTSE 94,000 - still has gremlins!
1995 R100RT Classic 16,650 crashed - repaired!
1992 K75RTP 46,000

"We shall not all die, but we shall all be changed."
Back to top
View user's profile Send private message Send e-mail Visit poster's website
molerat
Big Brick Rider


Joined: 14 May 2012
Posts: 69
Location: Phoenix, AZ

PostPosted: Fri Nov 07, 2014 10:08 pm    Post subject: Reply with quote

So I should change the title to "ticking", thats more what it sounds like and still a mystery...could it be the throttle bodies need adjusting?
As mentioned earlier it seems to mostly do it when letting off the throttle fast.

Checked clearance on ABS. seem ok. cleaned contacts but still no go. Will have to check codes if I can manufacture the tool.
_________________
Brian

1995 K1100 LT
1952 HRD Vincent Black Shadow, Series C
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    K11 Owners Group Forum Index -> Tech All times are GMT - 4 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group