| View previous topic :: View next topic |
| Author |
Message |
Mystic Red
Flying Brick Rider
Joined: 28 Mar 2005
Posts: 2330
Location: Twin Lakes Idaho
|
 Posted: Sun Mar 15, 2009 6:49 pm Post subject: Torque? |
 |
|
Specs for the control arm bolt that attaches it to the final drive? Clymers has me running in circles.
_________________
Scott Hespelt, '94 K11LT
K11 OG #466 |
|
| Back to top |
|
 |
Scott_Anderson
Site Admin
Joined: 05 Sep 2006
Posts: 3122
Location: Central Iowa, USA
|
| Posted: Sun Mar 15, 2009 8:30 pm Post subject: |
|
|
Well, I couldn't find in the torque chart for the control rod bolt specifically.
But, by the fact that the bolt is a 10mm, from table 2 "general torque spec's" you should be safe with 25-39Nm for a 10mm bolt.
I think I set mine around 32Nm when I did my spline lube on my '97.
_________________
Ride safe.
1995 K1100LT 0302044
2017 FLHTK Ultra Limited
Garmin StreetPilot 2820
Garmin Zumo 550
Garmin Zumo XT
"One who does not ask questions is ashamed to learn" Danish proverb
1997 K1100LT 0302488(R.I.P.)
1997 R1100RT ZC62149(sold) |
|
| Back to top |
|
|
kengibson
Brick Rider
Joined: 22 Aug 2008
Posts: 30
Location: Colorado, Boulder area
|
| Posted: Sun Mar 15, 2009 8:48 pm Post subject: |
|
|
The factory repair manual says 43Nm. It's on page 254 if you have the .pdf file. It took me a while to find this one too when I reassembled mine last month.
_________________
'95 K1100RS with only 47k miles |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
