| View previous topic :: View next topic |
| Author |
Message |
michaelcurrin
Flying Brick Rider
Joined: 01 Jun 2003
Posts: 329
Location: eastern NC
|
 Posted: Sat Jul 02, 2022 9:22 pm Post subject: extra part K1100RS |
 |
|
For various reasons the K1100RS sidecar rig has been sitting in pieces for several months. Finally started putting her back together. All the parts are bagged and each bag is labeled, however have this one "wave washer that was in the bag with the bits for the hall sensor that I can not figure out where it came from. Have looked through the shop manual, Max BMW parts web site, and google.
Any ideas?
_________________
Mike Currin
20 BMW R1250RS
93 BMW K1100RS / EML Speed 2000
06 Ducati ST3
67 Triumph 650 chopper |
|
| Back to top |
|
 |
Flying Duck
PsyKotic Waterfowl
Joined: 27 Jan 2005
Posts: 10085
Location: Bumf***, WA
|
| Posted: Thu Jul 07, 2022 2:40 pm Post subject: |
|
|
I don't recall ever seeing that part. It doesn't go between the rotor cup and little round plate.
Did you remove the rotor flange at the end of the crank shaft? That the plate and rotor cup attach to?
_________________
93 LT (x2)
94 RS
86-97 K75F(K75/100/1100 Frankenbrick)
86 K75C w/paralever, hi perf cams,TURBO!
91 & 92 K75Ss
91 K1
86 custom K100
14 WR250R
IBA #17739 (SS1K, BBG, 50CC)
Buy parts HERE |
|
| Back to top |
|
|
Grunter
Flying Brick Rider
Joined: 30 Sep 2015
Posts: 368
Location: North East England
|
| Posted: Fri Jul 08, 2022 3:23 am Post subject: Whotsit! |
|
|
Without something to give it scale it is difficult to identify, but going by the large hole in the middle it looks like a wave washer that is on the brake discs to stop the disc rattle
_________________
1997 K1100LT
1994 R1100RS |
|
| Back to top |
|
|
michaelcurrin
Flying Brick Rider
Joined: 01 Jun 2003
Posts: 329
Location: eastern NC
|
| Posted: Fri Jul 08, 2022 10:52 am Post subject: |
|
|
| Quote: | | Did you remove the rotor flange at the end of the crank shaft? That the plate and rotor cup attach to? |
Nope, did not remove the rotor flange. I removed the front cover of the motor to access the cam chain tensioner.
| Quote: | | Without something to give it scale it is difficult to identify |
It's a bout the same outside diameter as the rotor cup, so about 2 inches give or take. Definitely not from the brakes.
_________________
Mike Currin
20 BMW R1250RS
93 BMW K1100RS / EML Speed 2000
06 Ducati ST3
67 Triumph 650 chopper |
|
| Back to top |
|
|
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
