K11 Owners Group

The stock warning bulbs are 3W. The 4W bulbs are for the two turn signal bulbs.

I run LEDs in my K11 clusters. They're 0.2W. And they're early LEDs so they are polarized and don't allow a reverse ...

Green wire which is switched power to the instrument cluster.

The Motronic grounds the coolant temp warning bulb to illuminate it.

160 is about normal for a K.

You can adjust when the fuel light comes on without bending the float rod. (Which is tempered and very hard to bend.)

You need to remove the fuel level sender from t ...

Here are the BMW wiring diagrams for a 94+ K1100 with English notation that I added:

http://www.kbikeparts.com/classickbikes.com/ckb.tech/0.ckb.tech.files/kwiring/K1100RS.94on/K1100RS.94on.Wiring.S ...

The temp sensor on the bottom of the water pump does not impact operation AT ALL. It only feeds the temp gauge.

The Motronic ECU reads the temp of the coolant coming off of the cylinder head's exit ...

Drove back from Seattle area (Copalis beach)

Sanjiv

Rolling Eyes

I think your Tesla has a bad GPS. Copalis is well over 100 miles from Seattle.

https://goo.gl/maps/DN9mtNTSEfQmBCy29

How many miles are the tires warrantied for? I've read that EVs eat tires more quickly due to the weight.

You should phase the front and rear U-joints:

http://www.kbikeparts.com/classickbikes.com/ckb.tech/0.ckb.tech.files/dsphase/dsphase.htm

Motorcycle boots generally do not have heels because the front edge of a heel can snag on pavement cracks.

That said, I have a pair of black elephant skin ropers that I sometimes wear riding locall ...

So did you replace the Motronic?

Here's how NO (normally open) relays, like the relays in a K, work:

When you have 12V at 86 and ground at 85 it energizes a coil that connects the source, usually 12V at pin 30 to the output pin 87 ...

I'm not fishing in any pond. I'm telling you the truth.

If your fan comes on at 80F then there is something wrong with your K1100.

Here's how the cooling system is designed to work:

There is ...

The radiator fan should not come on until the coolant temperature reaches 221F.

Did you or a prior owner add a fan switch? The fan should not be coming on.

Current flows through the fuel pump. That's what makes it run. If it didn't have continuity between the pos and neg terminals then it wouldn't run.

Check for continuity from the green/white wire of the tank side of the connector and the smaller diameter terminal on the fuel pump.

Check for continuity from the brown wire of the tank side of the ...

The white and yellow wires have absolutely nothing to do with fuel pump operation. Ignore them. (Yellow is the fuel level to the gauge and white is for the low fuel warning lamp in the instrument clus ...

Are you turning the axle when installing it? (Via the hole in through right end.)

That can help.

Prying "the pinch" of the left fork apart a little probably wouldn't hurt but I wouldn' ...

The axle should have a decent coat of grease on it.

When the end of the axle gets to the left fork does it enter the hole in the left fork at all?

Does the axle go through without the wheel? If ...

Bought a used car in October. The radio head unit kept losing its station memory and would not Bluetooth pair with my phone.

So I bought a decent new Kenwood head unit and installed that.

Drive ...