K11 Owners Group

bbmw · Joined: 18 Apr 2008 Posts: 2 Location: Connecticut

I have a small leak on my '96 KLT oil pan seam between engine block and pan.
I did the clean the engine with Gunk and power washer thing and
re-torqued the pan bolts to spec.
I see BMW does not believe in using gaskets here, so my next question was what type of sealer do I use after taking the pan off, clenaing it up and reinstalling?
Thanks

Tim (Midland Section) · Posted: Sat Mar 28, 2009 6:36 pm Post subject:

I use clear silicon bath sealant sparingly, if it can stop a Norton being incontinent, no trouble on a Beemer Laughing

_________________
Regards Tim,

Grey haired riders don't get that way by pure luck
1996 Guzzi Cali3 LAPD
1972 750 Commando
G6HRN
#485

Jim · Posted: Sat Mar 28, 2009 6:38 pm Post subject:

I suppose any silicone sealant might work - but since there are silicone sealants made especially for engine and transmission work, I would use one of those rather than the kitchen and bath type.

Remember to give it plenty of cure time before running the bike.
_________________
Jim
1997 K1100LTSE 94,000 - still has gremlins!
1995 R100RT Classic 16,650 crashed - repaired!
1992 K75RTP 46,000

"We shall not all die, but we shall all be changed."

RAL88 · Posted: Sat Mar 28, 2009 8:18 pm Post subject:

This is what I used on my K1100, no leaks and I just used it on the oil pan for the k100.

http://www.permatex.com/products/Automotive/automotive_gasketing/gasket_makers/auto_Permatex_Ultra_Black_Maximum_Oil_Resistance_RTV_Silicone_Gasket_Maker.htm
_________________
Rich

"If it ain't broke, take it apart and make it work better"
*************
'96' K1100LT-SE
'97' R850GS-R

Flying Duck · Posted: Sat Mar 28, 2009 8:37 pm Post subject:

I used gasket sealant when I replaced the bellhousing on my K75RT - worked great.
_________________
93 LT (x2)
94 RS
86-97 K75F(K75/100/1100 Frankenbrick)
86 K75C w/paralever, hi perf cams,TURBO!
91 & 92 K75Ss
91 K1
86 custom K100
14 WR250R
IBA #17739 (SS1K, BBG, 50CC)
Buy parts HERE