K11 Owners Group

So, how does one remove the O-ring and install a new on. Is there a way for oil that lubs the push rod bearing drains back to tranny basin?

So, I tore into the bike again to figure out where oil organiation is - as I took off boot for clutch depression rod at the back end of the transmittion, a bunch more oil came out. The face of the tra ...

So, I replaced my clutch, o-ring, and seal about 500 miles ago, and I noticed a new drip out the weep hole the other day (damn). Anyway, I had also noticed my oil line on the sight glass was too high ...

Replaced clutch, o-ring, seal etc about 500 miles ago and noticed new oil leaking out the weap hole tonite. Damn I hate to "do it again". Wonder what I did wrong? Any experienced thought ...

Did a clutch job, but didn't take a pic of this bracket on rear brake. so, not sure how it mounts or it's purpose. See attached pic.

http://www.flickr.com/photos/28892356@N08/6865573970/

Tha ...

I was asking my local shop about Mich PR2 tires for my LT and they said you cannot use radials due to load requirements? I am not a tire guy, so some enlightenment would be helpful. Currently runnin ...

So I did a clutch job, but didn't take a pic of how sidestand switch mounts.
Can someone help me? Thanks in advance

Sorry Jeff, but I am not sure what you mean by "fork lowers"? I did take the fork slider off to replace the seal and dust cup which revealed a lot of debre in the bottom of the slider tube. ...

I am conflicted about the amount of fork oil required on a 96K1100lt when both forks are completely empty - I.E. I replace seals and therefore cleaned out reservoir completely by removing the "in ...

How does one clean/maintain the seperator in the air box? http://www.flickr.com/photos/28892356@N08/6858292599/in/photostream

I am not sure if this should get molly on it or not. Can someone answer this? Confused

Thanks for the advice Phil. I"ll pull it apart and clean the guard dog grease off.
Does anyone know an easy way to get the forward rubber boot for the the shaft housing back on. Its the boot ...

Doing clutch replacement and wondering do I need to lube the spline connection between clutch housing and engine shaft or is this bathed in engine oil? It is "up steam from the o-ring, which I as ...

Doing a clutch job.
How do you get the electrical harness to release on the ABSII. I got the bottom part free, but the top is hooked on something. Thanks in advance.

Need to replace fork seals: Anybody got a link or pix for doing this on the bike (if possible?) or a link to
doing it off the bike (pix or process)? Thanks in advance.

Is there a post that shows how to do this (I.E. pix)?

So back to the rear main seal - how does one know if it needs replaced or not. I.E. - oil dripping out, physical burn, or what - thanks.

Any tricks to installing a new seal and keeping the face at 0.5 mm above the block surface?

Do you know where the fuse is located?