K11 Owners Group

Like your user name - we most likely work for the same employer.

If you start having buyers remorse give me a shout - I have owned several K-bikes if the past - have one now with 3 wheels on it ...

Do a search on here - the water temp sensor has caused similar problems.

Thanks guys for all the input - I had mine weld repaired - sure wish I had seen this repair first.
I also added another bolt in between the two original bolts.
Also thinking of adding a type o ...

For a 1993 K1100LT - this is the piece that bolts to the forward frame w/4 small bolts.

Most likely will be found bent or cracked/broken.

Mine has 3 of the 4 corners broken.

One on E- ...

Not mine but anyone wanting to "cafe" a "K" bike needs these.

http://greenville.craigslist.org/mpo/4948540119.html

How does it run/ride?

I believe those holes are fairly deep - you may be alright with another heli coil set a bit deeper - with longer bolts.
There are several different manufactures out there also - I have some called ...

I had an engine temp sensor that sort of did that same thing. Sometimes run fine for a few days and then cut out when hot.

There are two of them - one for the temp gauge only and one for the com ...

Read the mans posting again - he marked the d/shaft with a sharpie and determined it had spun inside the rubber sleeve.

Stop trying to make it a clutch issue.

I would also mark the camshaft retaining caps so as to reinstall in the same place.

And before installing & torquing the camshaft sprocket check your valve clearances - although on second tho ...

Hello from Gastonia NC.

For your next trip you could try a ride up to http://diannasshop.com/

Located a bit south of Asheville and talk seat mods with them. A friend had a

BMW GS seat restuf ...

blue light flashing --

The lyrics at 4:33 are some of my favorite from any song. "One thing I have found, there are just two ways to go, it all comes down, to living fast or dying slow."

from "Dreadful Se ...

Here's another way to do it - will take about $6-700 to do - parts;labor;shipping

I had the 2:54 gear set

from a R1200CL installed in my K1100 housing. Work done by Anton

Largiader @ h ...

Air Filter - 13721460337
Fuel Filter (goes on pump inlet) - 16141341233
Clutch Cable - 32732324960
Cam Followers (3ea) - 11327666056 (3.200) not pictured

EBC brake pads - front - one caliper - F ...

Next time you go thru Franklin NC try a western heading on "WAYAH RD. #1310.

http://i188.photobucket.com/albums/z190/davenorris/DSC04071.jpg

Hows about this one ?

$75 shipped as you see it

SOLD

http://www.ascycles.com/SearchResult.aspx

Will send it to you for $25 to a USA address.

You got to crawl before you can walk.

Besides, when you spend several hours sitting in a bar it's hard to roll up the big miles.