K11 Owners Group

Okay, thanks for your input and also this useful website.

Hi
Thank you for your replies and thoughts.

The bike has 138.000 miles on the clock, most of them mine. That bush must be due for replacement and/or, add some washers, as required on the bolt to r ...

Hi All.
I want to try and reduce the lean angle of the bike.
By removing the bolt, Im wary that because of limited space, I wont be able to juggle the parts mechanism back into place.I dont want to ...

I have a 1994 K1100rs. I want to replace the crankshaft oil seal in the timing case cover, using the original type oil seal and not the teflon type that BMW only seem to sell now.
With the Hall sens ...

Thanks very much for your replies and ideas. I will attempt to put both ideas into practice, then choose one!!
As today is particularly grey outside its a good day for a fiddle in the garage. Not t ...

Yeh, Iv seen the thread, very interesting by Mr duck Surprised

But there are no specific details as to how to connect/bypass the wiring so that a warning light is on when sidestand is down.
Iv tried pl ...

Hi Ya-all
I would appreciate some help from you electrical wizards out there. There is mention in past forums regarding a side stand warning light, but Im as thick as my brick electrically Rolling Eyes

...

Hi Joeangi
I too would be curious of others folks feedback on this one.
All I can say is I`v had Ks for many years now and found some small quantity of oil seep through into the rubber boot over ti ...

[quote="BMW_Mick"]Hi all,

I have just got a '94 'LT, but it has a couple of problems, one of which is that the fuel consumption is not what I expected, I can only get about 160 miles befo ...

Aries, welcome to the forum. What was the problem with your bike cuttting out?

Hi Geoff
Cant give a definative answer to why the bike faltered and cut out. However after much poking and wire check ...

Hi
Am in Shepperton, not far from Guildford and a nice hack down to Bahnstormers every so often.
Do as much as possible of my own servicing, but limited garage space for too much spanner wielding.

Greetings all
Thanks for your replies. I will endevour to post some piccys up of the machinery, but having just grown accustomed to the ribbon typewriter, it may be a while!!
The K1100 has 92,000 on ...

Just to say "Hi everyone".
I am in West Londonh and have been reading these forums for quite a while now---a hive of information indeed on the, slightly long in the tooth but wonderfull K11 ...