K11 Owners Group

1) As mentioned above the rear brake master cylinder is attched to the hanger. I have not found a way of swapping the hanger without removing the brake line from the master cylinder - and therefore re ...

I just removed the back half of the fender and used a bent piece of alumimum to hold the license plate.

has worked well so far

Oh I love your wheels, what are they off??
Rob

So was mine.....

OMG, how scary was that.

Has anyone produce a maintenance "how to" check list to help us identify any early warning symptoms, such as how much backlash at the rear wheek should there be w ...

Ahh yes the backfiring Smile

You can minimize that by properly adjusting your throttle shut-off switch.

Is there any to MAKE them backfire, Its so funny watching cage drivers in tunnels jump when m ...

Got to de different ratio's, My LT is nearly at the redline doing 130mph while my RS did 145mph and was still under it, Mine is and LTIC so the plod might have had it played with, The FD is the correc ...

I have 2 sets of lights mounted under my fairing and a HID headlight + all indicators as running lights.
I do like to be seen Laughing

Rob

Its going to be Input shaft seal I recon, I dont think that the clutch operating rod has gearbox oil seal but it might have, Either way its going to be Tranny off Crying or Very sad

Rob

Well the new shaft is in and working but when I took the back (front?) half of the shaft out of the swinging arm I found the rubber had started to break up, don't know if that was as a result of the j ...

It was scary when it went, the noise was so loud I thought the whole back end had come off Shocked

Got a replacement ordered, got to drive a 440 mile round trip to get it though but need her back ...

This really scares me! Are these UJs normally a maintenance thing ie should they be lubed? I'll look up the Clymer tonight after work.

No way of lubing them, factory sealed, how dry they were is ge ...

The original driveshaft had done 104,000 miles and the joints had "rough spots" that I found when I rebuilt the engine output shaft last August, so I used the one off the donor engine/trans ...

Hi All.
On the way home from work today I pulled away frm traffic lights (a bit rapid to beat a car) got 50 yards from the line and BANG CLATTER SKID...... rear wheel locked up solid, managed to roll ...

Maybe if our army was as big as yours we could get the oil prices down ! Very Happy

I thought you guys were over in Iraq stealing oil with us. I guess you're not getting your fair share. Laughing

Nah a ...

I bought two lots, just recieved my service kit off ebay so as soon as I've chipped the frozen snow off the cover I'll get down to the service !

If there is a RANGE shop near you they are doing Uni ...

EP, I supose the questions is: do you have a radio in the left pocket?
I guessing that since you said "pocket cover" instead of "radio cover" you are looking for the flat cover i ...

How do you get the rubber grommet in place if you don't remove the battery tray?

You can do it from inside the trans housing using a long screwdriver to push it down from the top.
Rob

Hi Chris
They are supposed to be a sealed unit but Im sure that a few people on here have been able to strip them down, the bezel that holds the glass on is crimped over when they are made but with a ...

Sprayed the bugger real good with tuner cleaner and gave it a half hour to dry out. Still no change, only shows 4th or 5th gear. Always 5th when it is in any gear and always 4th when it is in one of ...

Thought things were going along well until this afternoon. Put power to the bike today and discovered that the tranny shift indicator did not work. Well, It turns out I had plugged it into the lead ...