K11 Owners Group

Well that's the thing, I can't get the 4444 code. I adjusted the tps again to the temp light on the gauge cluster. In order to get the light on at closed throttle the voltage is .366. not much of a di ...

I replaced mine with a used one ebayed a whole throttle body set with the sensor. The original one had like a dead spot in it while riding, around 2200 rpm. I installed the new one set it with a mult ...

Bending up some brackets today at work to support the rear of the engine in the frame.. had a clutch centering tool made up today also.
So I can get into it a little deeper this weekend.

I started with a clutch job , and replacement of all the seals .
Now I want to go a bit deeper and take a look at at the output shaft in the crankcase. Trying to track down the rattle/ light knock no ...

BMW used the staburags. Not sure on the spelling?
After digging deeper into this intronet.
Castrol makes a equevalient lube? Less expensive and way easier to obtain. This seams like the way to go. ...

Question, what is the most common lubricant used for the clutch splines? Where does everyone get it?
Thanks again!

Yes it was a simple procedure, although I had removed the adjustment bolt and lever and left the boot clamped in over night. The next morning. The spring pressure had ripped right through the boot, wi ...

Well the simple truth of it is we bought this blue brick to ride, not sit in the barn and make the Sabre envious!
I decided to go to the BMW dealership after work yesterday, to see what they might h ...

I did check the clutch adjustment, and it was real close to spec. Then I decided to go through the procedure any way to see how difficult it was without removing anything. Not bad at all. Though the j ...

First thanks for the part # ! Yes to the socket seal driver start it and strike as squarley as possible. At minimum have to remove the tire. When you did it did you remove the final and the shaft as ...

I hope this is the proper section to carry on with my questions.
Is there a write up or post, on replacing the clutch push rod oring
The links that where ( so graciously) provided took me to the mai ...

That would be awsome, I will follow the link and also refer to the climer manual that came with the bike.

Thanks for your input.

The gear lube is leaking from the week hole not bad enough to leave a puddle on the floor, but it's burning on the exhaust.

Is this a topic for the tech forum?

I bought a 94 K1100 lt last Friday.
Might have just paid someone for there headache?
My Wife actually talked me into it, saying any classic Bike I was to get I have to wrench on. Plus I had been lo ...